Switch Template

Share this document
  • Last update: 23 July 2013

124SSR / 123SC / 123DR Tactile Switch Template

Remove the template from the owner’s manual by cutting around the dashed rectangular perimeter line.

Align the 3/16" (.48 cm) drill bit with each of the four black circles and drill straight down through the helm, providing clearance for the mounting hardware provided with the switch.

Align the centering bit of a 2" (5.08 cm) hole saw with the cross hairs in the center of the 2" (5.08 cm) dashed circular perimeter and drill straight down through the helm, providing additional clearance for switch and electrical connection.

Tactile Switch Connection

Mount control box within 24" (60.96 cm) of keypad. Control box wire harness is 30" (76.2 cm) in length.

122 Double Rocker Switch Template

Remove the template from the owner’s manual by cutting around the dashed rectangular perimeter line.

Align the centering bit of a 2.25" (5.715 cm) hole saw with the cross hairs in the center of the 2.25" (5.715 cm) dashed circular perimeter and drill straight down through the helm, providing additional clearance for switch and electrical connection.

Before drilling the four switch mounting holes, drill a small pilot hole using a 1/8" (.3175 cm) diameter drill bit. Make sure pilot holes are straight. 

 

End of page 22


 

Comments (0)

Leave a comment

You are commenting as guest.