The only single actuator Extreme Duty design offered. This kit is similar to our Heavy Duty Performance series with a thicker, stronger blade for those boaters who run hard in extreme conditions. Boat lengths 20’ (6.1 m) to 40’ (12.2 m). Blades are constructed of Electro-Polished 10 gauge (3.4 mm) laser cut 304 stainless steel with 1” (2.5 cm) turned up edges and a 5 degree taper on the inside, heavy duty hinge with 3/8” (9.5 mm) diameter hinge pin. Full transom back plate with mechanical strain-relief cable seals, welded on stainless steel upper & adjustable lower actuator mounting brackets, 3/8” (9.5 mm) stainless steel mounting bolts. 3.75” (9.5 cm) sacrificial anodes installed.

• L" X W": 17" x 12"
• Boat Length: 20' - 40'
• Min. Transom Height: 10.5" (26.7 cm)
• (2) 10-gauge stainless steel Electro-Polished blades
• (2) 15056-001 XD Extreme Duty actuators with 6' (1.8 m) leads & Deutsch connectors
• Lenco owner's/installation manual
• Note: Boat-mounting hardware to be supplied by the customer
• Note: Actuator extension harnesses not in kits, must be purchased separately (2 required)